Easy Ways To Kill Mold And Mildew In The HouseMold growth can cause dangerous health complications that range from mild allergies to depression. Molds create mildew, which is a multiplying organism that is bluish green to gray in color. Damp, less ventilated, dimly lit and warm areas are the conditions that promote growth of mold and mildew. To kill mold and mildew, the foremost thing is to eliminate these favorable conditions and permanently solve the problem of dampness in the house. Water from leaky pipes, utility backup and condensation from dehumidifier or air conditioner prompts mold growth. A few building materials like drywall, wood, insulation, wood flooring and plaster increase the moisture considerably.
There are various ways in which different areas can be treated where mold growth is observed. Mold that grows on hard surfaces like floors and walls can be killed by the use of disinfectants. However, you must take notice that the disinfectants which are used must have an EPA (Environmental Protection Agency) registration number mentioned on their product label. Chlorine bleach is an inexpensive and effective disinfectant to get rid of molds on hard surfaces. Bleach that comprise in 5.25 percent of sodium hypochlorite must be used. The solution should be kept for 10-15 minutes over the affected area. Be careful not to mix this bleach with any of the household cleaners that contain ammonia. Before you initiate the disinfection process, you must use a detergent solution to clean the affected hard surfaces. Natural fibers and woods are usually the most affected areas in the house. You may brush off the mold outdoors. This will avoid the spores to get scattered inside the house. If you use a vacuum, cleaner bag should be disposed as it is likely to consist of fungi that produce mildew. Ozone generators are another method used for the removal of mold and mildew. These generators employ 'high ozone shock treatment' for the treatment of mold contamination. Ozone is produced by these generators as the oxygen is converted into ozone via high voltage. Mold is oxidized by ozone which makes it incapable for reproduction and kills it gradually. For removing and decontaminating the mold and mildew growth effectively, it is important to apply high ozone concentration. The final step is to remove dead mold along with other contaminated materials. This would help you prevent reoccurrence of mold and mildew growth in the house, which would thereby assure a clean and healthy environment to your family members. Among the household products, vinegar, extracts of grapefruit seed and tea tree oil are the three most effective solutions to kill mold and mildew. Though all three do assure successful cleaning of mold and mildew, but all of them have their pros and cons that must be analyzed beforehand to find the solution that works best for you. |